Anthony Sepulveda Posted December 11, 2014 Share Posted December 11, 2014 Hello, Is there a way to use the AGREE connector using the command line? Or maybe a feature can be added to the Construct palette: that it shows how the building blocks translate into command line code. This way, with more time and practice, for some it would be faster to just type in the commands instead of dragging, dropping and clicking on the graphical interface. Thanks. Link to comment Share on other sites More sharing options...
Helen Brown Posted December 11, 2014 Share Posted December 11, 2014 How would you indicate not only what the agreement was (that can be inside the brackets) but what words are agreeing as they may not be adjacent? That's the whole point of the construct, it lets you define the words and then set up complex relationships between them. Link to comment Share on other sites More sharing options...
Anthony Sepulveda Posted December 11, 2014 Author Share Posted December 11, 2014 Ok, so there's no way to do it by command line then. Link to comment Share on other sites More sharing options...
Ken Simpson Posted December 11, 2014 Share Posted December 11, 2014 That’s what Helen is saying Anthony. There is no typed in syntax to specify the complex relationships that can come with the AGREE command. Link to comment Share on other sites More sharing options...
.png.c3123c857d1029f98e39c9394adc358d.png)
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now