Jump to content

(Check for Updates) -> Partially successful installation


Ulf

Recommended Posts

Hi

 

I've come across an odd workflow/problem with regards to 'Check Update'.

 

My setup:

MBPro i7, 8GB RAM, OSX 10.6.5

Accordance 9.1

 

1. I did a 'Check Updates' and it told me at there were 33 updates.

2. I clicked 'Download' and waited until all were downloaded.

3. I clicked Install, and Accordance flickered about 7 times.

4. The attached screenshot showed up.

post-30334-070351400 1291224896_thumb.jpg

5. I searched the documentation and forum for 'partially successful', 'update', and 'upgrade', but came up blank, hence this post.

 

I 'solved' it by checking for updates and downloading 3 at a time. It took a long time, but was finally done. Perhaps there was a 10 at a time limit, but didn't want to experiment.

 

I hope this can be of some use to someone.

 

All the best.

 

Ulf

Link to comment
Share on other sites

Hi

 

I've come across an odd workflow/problem with regards to 'Check Update'.

 

My setup:

MBPro i7, 8GB RAM, OSX 10.6.5

Accordance 9.1

 

1. I did a 'Check Updates' and it told me at there were 33 updates.

2. I clicked 'Download' and waited until all were downloaded.

3. I clicked Install, and Accordance flickered about 7 times.

4. The attached screenshot showed up.

post-30334-070351400 1291224896_thumb.jpg

5. I searched the documentation and forum for 'partially successful', 'update', and 'upgrade', but came up blank, hence this post.

 

I 'solved' it by checking for updates and downloading 3 at a time. It took a long time, but was finally done. Perhaps there was a 10 at a time limit, but didn't want to experiment.

 

I hope this can be of some use to someone.

 

All the best.

 

Ulf

 

I had the same issue as well. Ended up doing no more than 5-6 modules at a time and they finished successfully.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...