Jump to content

A Few More Bugs?


Steve Lo Vullo

Recommended Posts

Hi Everyone:

 

Thanks for clearing up some of the bugs in 9. I think I still have a few remaining, and one that is new with 9.0.3.

 

The old ones are:

 

(1) When I create a zone with several tabs and save the session, when I reopen the session, the tabs that were in front are usually not the front tabs when I reopen the session. Normally I select the tab I use most often, so it would be much better if the tabs I have selected when I save the session are the tabs that are selected when I reopen the session. This was happening before the most recent update.

 

(2) A related problem is that the workspace in front when I save the session does not alway come up as the front workspace when I reopen the session. This was also happening before 9.0.3.

 

A new problem is a certain amount of unresponsiveness in 9.0.3. When I click on one tab from another, there is a slight hesitation. This isn't very serious, but I thought I would mention it. But a bigger problem is that when resizing a window by dragging the bottom right corner, there is significant hesitation. I just noticed that I am also getting significant hesitation when scrolling with the mouse. Seems to be some hesitation in tabbing, too.

 

Thanks

Link to comment
Share on other sites

One more thing I forgot. When I click on the resize button (+), the window shrinks down to a tiny rectangle in the top left corner. Then I can't even resize it, because the top of the window is hidden under the menu bar, so I can't access the resize button. Even dragging the window open by the bottom right corner is no good, since the top of the window is under the menu bar and cannot be accessed to pull the whole window down.

Link to comment
Share on other sites

 

(1) When I create a zone with several tabs and save the session, when I reopen the session, the tabs that were in front are usually not the front tabs when I reopen the session. Normally I select the tab I use most often, so it would be much better if the tabs I have selected when I save the session are the tabs that are selected when I reopen the session. This was happening before the most recent update.

 

 

This sounds like the same bug I had previously reported. See this post: Default Startup Session Issue

 

In my experience, the zone not saved as the selected zone will jump to the far right hand tab upon program startup.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...